Guarantee Your Safety And Avoid Potential Slowdowns - Things To Check Before A Boiler Inspection
Despite all advances in modern technology, a high pressure boiler system remains one of the most effective ways for transmitting heat throughout a large facility. When it comes time to have a new boiler installed, however, there are a variety of steps you need to take in order to ensure the safety of those in the area and guarantee that you pass inspection from all relevant authorities.
Below, you'll find a guide to some things you should be sure to check before you have your boiler inspected. Verifying that these potential sources of trouble are covered can help make sure that you don't end up with lengthy shut downs and delays, and instead will promote the easy operations that you desire.
Verify Safety Markings
The primary concern of your boiler installation inspector is safety. Though new automatic shutdown systems have made operating a boiler safely nearly foolproof, the specter of past explosions still casts a wide shadow that colors boiler requirements to this day.
Your emergency shutoff control should be located outside of the boiler room in a clearly marked and easily accessible area. You should also be sure that all relevant safety controls located inside the boiler room are similarly well marked, and the room itself should be well-lit in order to guarantee a lack of confusion when operating those controls.
Guarantee Correctly Sized Fittings
Proper fittings are essential for maintaining the smooth flow of water and the efficient operation of your boiler, but they're also necessary in order to satisfy the wishes of inspectors. Each type of steel fitting has its own requirements, and you should verify your selections with your relevant local authority.
All pressure gauge connections will likely be checked during the boiler inspection process, so make sure that they're as secure as possible and also easily displayed. This will allow for a quick check rather than risking a temporary disassembly in order for your inspector to verify you've made the correct installation.
Openly Display Temperature Gauges
Perhaps the most important step in verifying the safe operation of your boiler is guaranteeing that it's running at the proper temperature. While a new boiler should be unlikely to run hot and exceed operational limits, your boiler inspector will still want to verify that things are operating correctly. Keeping the temperature gauges easily accessible and well-lit will guarantee a quick check, as well as put you in a position to operate your boiler smoothly once the inspection has ceased.
For more information about boiler installations and inspections, visit http://www.schweitzerbros.com/.